From 2d8aa56b51b0f79d7aad135b73f3414d77b56cda Mon Sep 17 00:00:00 2001 From: Dario Binacchi Date: Sat, 13 Sep 2025 11:16:31 +0200 Subject: [PATCH] ARM: dts: imx6ull-engicam-microgea-rmm: fix report-rate-hz value [ Upstream commit 62bf7708fe80ec0db14b9179c25eeeda9f81e9d0 ] The 'report-rate-hz' property for the edt-ft5x06 driver was added and handled in the Linux kernel by me with patches [1] and [2] for this specific board. The v1 upstream version, which was the one applied to the customer's kernel, used the 'report-rate' property, which was written directly to the controller register. During review, the 'hz' suffix was added, changing its handling so that writing the value directly to the register was no longer possible for the M06 controller. Once the patches were accepted in mainline, I did not reapply them to the customer's kernel, and when upstreaming the DTS for this board, I forgot to correct the 'report-rate-hz' property value. The property must be set to 60 because this board uses the M06 controller, which expects the report rate in units of 10 Hz, meaning the actual value written to the register is 6. [1] 625f829586ea ("dt-bindings: input: touchscreen: edt-ft5x06: add report-rate-hz") [2] 5bcee83a406c ("Input: edt-ft5x06 - set report rate by dts property") Fixes: ffea3cac94ba ("ARM: dts: imx6ul: support Engicam MicroGEA RMM board") Co-developed-by: Michael Trimarchi Signed-off-by: Michael Trimarchi Signed-off-by: Dario Binacchi Signed-off-by: Shawn Guo Signed-off-by: Sasha Levin --- arch/arm/boot/dts/nxp/imx/imx6ull-engicam-microgea-rmm.dts | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/arch/arm/boot/dts/nxp/imx/imx6ull-engicam-microgea-rmm.dts b/arch/arm/boot/dts/nxp/imx/imx6ull-engicam-microgea-rmm.dts index 5d1cc8a1f555..8d41f76ae270 100644 --- a/arch/arm/boot/dts/nxp/imx/imx6ull-engicam-microgea-rmm.dts +++ b/arch/arm/boot/dts/nxp/imx/imx6ull-engicam-microgea-rmm.dts @@ -136,7 +136,7 @@ interrupt-parent = <&gpio2>; interrupts = <8 IRQ_TYPE_EDGE_FALLING>; reset-gpios = <&gpio2 14 GPIO_ACTIVE_LOW>; - report-rate-hz = <6>; + report-rate-hz = <60>; /* settings valid only for Hycon touchscreen */ touchscreen-size-x = <1280>; touchscreen-size-y = <800>;