clk: bd718x7: Support ROHM BD71828 clk block

BD71828GW is a single-chip power management IC for battery-powered portable
devices. Add support for controlling BD71828 clk using bd718x7 driver.

Signed-off-by: Matti Vaittinen <matti.vaittinen@fi.rohmeurope.com>
Acked-by: Stephen Boyd <sboyd@kernel.org>
Signed-off-by: Lee Jones <lee.jones@linaro.org>

drivers/clk/Kconfig

@@ -305,10 +305,10 @@ config COMMON_CLK_MMP2
 	  Support for Marvell MMP2 and MMP3 SoC clocks
 
 config COMMON_CLK_BD718XX
-	tristate "Clock driver for ROHM BD718x7 PMIC"
+	tristate "Clock driver for 32K clk gates on ROHM PMICs"
-	depends on MFD_ROHM_BD718XX || MFD_ROHM_BD70528
+	depends on MFD_ROHM_BD718XX || MFD_ROHM_BD70528 || MFD_ROHM_BD71828
 	help
-	  This driver supports ROHM BD71837, ROHM BD71847 and
+	  This driver supports ROHM BD71837, ROHM BD71847, ROHM BD71828 and
 	  ROHM BD70528 PMICs clock gates.
 
 config COMMON_CLK_FIXED_MMIO

drivers/clk/clk-bd718x7.c

@@ -7,12 +7,25 @@
 #include <linux/err.h>
 #include <linux/platform_device.h>
 #include <linux/slab.h>
-#include <linux/mfd/rohm-bd718x7.h>
+#include <linux/mfd/rohm-generic.h>
-#include <linux/mfd/rohm-bd70528.h>
 #include <linux/clk-provider.h>
 #include <linux/clkdev.h>
 #include <linux/regmap.h>
 
+/* clk control registers */
+/* BD70528 */
+#define BD70528_REG_OUT32K	0x2c
+/* BD71828 */
+#define BD71828_REG_OUT32K	0x4B
+/* BD71837 and BD71847 */
+#define BD718XX_REG_OUT32K	0x2E
+
+/*
+ * BD71837, BD71847, BD70528 and BD71828 all use bit [0] to clk output control
+ */
+#define CLK_OUT_EN_MASK		BIT(0)
+
+
 struct bd718xx_clk {
 	struct clk_hw hw;
 	u8 reg;
@@ -21,10 +34,8 @@ struct bd718xx_clk {
 	struct rohm_regmap_dev *mfd;
 };
 
-static int bd71837_clk_set(struct clk_hw *hw, int status)
+static int bd71837_clk_set(struct bd718xx_clk *c, unsigned int status)
 {
-	struct bd718xx_clk *c = container_of(hw, struct bd718xx_clk, hw);
-
 	return regmap_update_bits(c->mfd->regmap, c->reg, c->mask, status);
 }
 
@@ -33,14 +44,16 @@ static void bd71837_clk_disable(struct clk_hw *hw)
 	int rv;
 	struct bd718xx_clk *c = container_of(hw, struct bd718xx_clk, hw);
 
-	rv = bd71837_clk_set(hw, 0);
+	rv = bd71837_clk_set(c, 0);
 	if (rv)
 		dev_dbg(&c->pdev->dev, "Failed to disable 32K clk (%d)\n", rv);
 }
 
 static int bd71837_clk_enable(struct clk_hw *hw)
 {
-	return bd71837_clk_set(hw, 1);
+	struct bd718xx_clk *c = container_of(hw, struct bd718xx_clk, hw);
+
+	return bd71837_clk_set(c, 0xffffffff);
 }
 
 static int bd71837_clk_is_enabled(struct clk_hw *hw)
@@ -92,11 +105,15 @@ static int bd71837_clk_probe(struct platform_device *pdev)
 	case ROHM_CHIP_TYPE_BD71837:
 	case ROHM_CHIP_TYPE_BD71847:
 		c->reg = BD718XX_REG_OUT32K;
-		c->mask = BD718XX_OUT32K_EN;
+		c->mask = CLK_OUT_EN_MASK;
+		break;
+	case ROHM_CHIP_TYPE_BD71828:
+		c->reg = BD71828_REG_OUT32K;
+		c->mask = CLK_OUT_EN_MASK;
 		break;
 	case ROHM_CHIP_TYPE_BD70528:
-		c->reg = BD70528_REG_CLK_OUT;
+		c->reg = BD70528_REG_OUT32K;
-		c->mask = BD70528_CLK_OUT_EN_MASK;
+		c->mask = CLK_OUT_EN_MASK;
 		break;
 	default:
 		dev_err(&pdev->dev, "Unknown clk chip\n");
@@ -126,6 +143,7 @@ static const struct platform_device_id bd718x7_clk_id[] = {
 	{ "bd71837-clk", ROHM_CHIP_TYPE_BD71837 },
 	{ "bd71847-clk", ROHM_CHIP_TYPE_BD71847 },
 	{ "bd70528-clk", ROHM_CHIP_TYPE_BD70528 },
+	{ "bd71828-clk", ROHM_CHIP_TYPE_BD71828 },
 	{ },
 };
 MODULE_DEVICE_TABLE(platform, bd718x7_clk_id);

include/linux/mfd/rohm-bd70528.h

@@ -89,10 +89,6 @@ struct bd70528_data {
 #define BD70528_REG_GPIO3_OUT	0x52
 #define BD70528_REG_GPIO4_OUT	0x54
 
-/* clk control */
-
-#define BD70528_REG_CLK_OUT	0x2c
-
 /* RTC */
 
 #define BD70528_REG_RTC_COUNT_H		0x2d
@@ -309,8 +305,6 @@ enum {
 
 #define BD70528_GPIO_IN_STATE_BASE 1
 
-#define BD70528_CLK_OUT_EN_MASK 0x1
-
 /* RTC masks to mask out reserved bits */
 
 #define BD70528_MASK_RTC_SEC		0x7f

include/linux/mfd/rohm-bd71828.h

@@ -183,9 +183,6 @@ enum {
 #define BD71828_REG_CHG_STATE		0x65
 #define BD71828_REG_CHG_FULL		0xd2
 
-/* CLK */
-#define BD71828_REG_OUT32K		0x4B
-
 /* LEDs */
 #define BD71828_REG_LED_CTRL		0x4A
 #define BD71828_MASK_LED_AMBER		0x80
@@ -417,7 +414,6 @@ enum {
 #define BD71828_INT_RTC1_MASK				0x2
 #define BD71828_INT_RTC2_MASK				0x4
 
-#define BD71828_OUT32K_EN				0x1
 #define BD71828_OUT_TYPE_MASK				0x2
 #define BD71828_OUT_TYPE_OPEN_DRAIN			0x0
 #define BD71828_OUT_TYPE_CMOS				0x2

include/linux/mfd/rohm-bd718x7.h

@@ -191,12 +191,6 @@ enum {
 #define IRQ_ON_REQ		0x02
 #define IRQ_STBY_REQ		0x01
 
-/* BD718XX_REG_OUT32K bits */
-#define BD718XX_OUT32K_EN	0x01
-
-/* BD7183XX gated clock rate */
-#define BD718XX_CLK_RATE 32768
-
 /* ROHM BD718XX irqs */
 enum {
 	BD718XX_INT_STBY_REQ,