With the module notification message the information about the notification
is provided via the mailbox with the sof_ipc4_notify_module_data struct.
It contains the module and instance id of the sender of the notification,
the event_id and optionally additional data which is module and event
specific.
At the same time add definitions to identify ALSA kcontrol change
notification.
These notifications use standardized event_id, modules must follow this if
they support such notifications:
upper 16 bit: 0xA15A as a magic identification value
lower 16 bit: param_id of the changed control
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@linux.intel.com>
Reviewed-by: Ranjani Sridharan <ranjani.sridharan@linux.intel.com>
Reviewed-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Link: https://lore.kernel.org/r/20231124150853.18648-3-peter.ujfalusi@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>
On Intel platforms there is a strict order requirement for the DMA
programming:
DSP side configures the buffer and sets the GEN bit
Host side sets the RUN bit.
In order to follow this flow, a new global message type has been added to
prepare the DSP side of the DMA:
host sends LOAD_LIBRARY_PREPARE with the dma_id
DSP side sets its buffer and sets the GEN bit
Host sets the RUN bit
Host sends LOAD_LIBRARY with dma_id and lib_id
DSP receives the library data.
It is up to the platform code to use the new prepare stage message and how
to handle the reply to it from the firmware, which can indicate that the
message type is not supported/handled.
In this case the kernel should proceed to the LOAD_LIBRARY stage assuming
a single stage library loading:
host sends LOAD_LIBRARY_PREPARE with the dma_id
DSP replies that the message type is not supported/handled
Host acknowledges the return code and sets the RUN bit
Host sends LOAD_LIBRARY with dma_id and lib_id
DSP receives the library data.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@linux.intel.com>
Reviewed-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Reviewed-by: Guennadi Liakhovetski <guennadi.liakhovetski@linux.intel.com>
Reviewed-by: Ranjani Sridharan <ranjani.sridharan@linux.intel.com>
Reviewed-by: Chao Song <chao.song@linux.intel.com>
Link: https://lore.kernel.org/r/20230915114018.1701-4-peter.ujfalusi@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>
In the chained DMA mode, the firmware allocates buffers for the host
and link DMA, and takes care of copying data between host- and
link-DMA buffers in a low-latency thread. This is different to a
regular pipeline, no processing is allowed, and the connection between
host- and link DMA is handled with a dedicated IPC.
This patch exposes the macros needed to create the required IPC messages.
Signed-off-by: Jyri Sarha <jyri.sarha@intel.com>
Reviewed-by: Rander Wang <rander.wang@intel.com>
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@linux.intel.com>
Link: https://lore.kernel.org/r/20230321092654.7292-3-peter.ujfalusi@linux.intel.com
Signed-off-by: Mark Brown <broonie@kernel.org>
