Switch from using driver specific ar->conf_mutex to wiphy->mtx. The benefits are:
* one lock less and simplified locking
* possibility to use wiphy_work_queue() without other locks
Most of the mac80211 ops are called within wiphy_lock(), most notable exception
being tx op. This can be checked with lockdep_assert_wiphy() from
net/mac80211/driver-ops.[ch] and I veried that by manually going through all
the ops in ath12k_ops which had lockdep_assert_wiphy().
The conversion was simple:
* All conf_mutex lock() and unlock() calls which
already were called under wiphy_lock() I replaced with
lockdep_assert_wiphy().
* The rest of conf_mutex calls I replaced with wiphy_lock() and wiphy_unlock().
* All lockdep_asset_held(conf_mutex) calls I replaced with
lockdep_assert_wiphy().
One exception was in ath12k_core_post_reconfigure_recovery() where the wiphy
lock needs to be taken before hw_mutex to avoid a lockdep warning.
Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.0.c5-00481-QCAHMTSWPL_V1.0_V2.0_SILICONZ-3
Signed-off-by: Kalle Valo <quic_kvalo@quicinc.com>
Link: https://patch.msgid.link/20241007165932.78081-4-kvalo@kernel.org
Signed-off-by: Jeff Johnson <quic_jjohnson@quicinc.com>
Whenever per pdev debugfs directory is created, a symlink to it is also
placed in ieee80211/phy* directory. During clean up of per pdev debugfs,
this symlink also needs to be cleaned up.
Add changes to clean up the symlink whenever the per pdev debugfs is
removed.
Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.0.1-00029-QCAHKSWPL_SILICONZ-1
Signed-off-by: Aditya Kumar Singh <quic_adisi@quicinc.com>
Acked-by: Jeff Johnson <quic_jjohnson@quicinc.com>
Signed-off-by: Kalle Valo <quic_kvalo@quicinc.com>
Link: https://msgid.link/20240529043043.2488031-4-quic_adisi@quicinc.com
The initial debugfs infra bringup in ath12k driver and create the ath12k debugfs
and soc-specific directories in /sys/kernel/debug/
For each ath12k device, directory will be created in <bus>-<devname>
schema under ath12k root directory.
Example with one ath12k device:
/sys/kernel/debug/ath12k/pci-0000:06:00.0
ath12k
`-- pci-0000:06:00.0
|-- mac0
To enable ath12k debugfs support (CONFIG_ATH12K_DEBUGFS=y)
Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.0.1-00029-QCAHKSWPL_SILICONZ-1
Signed-off-by: Ramasamy Kaliappan <quic_rkaliapp@quicinc.com>
Signed-off-by: Ramya Gnanasekar <quic_rgnanase@quicinc.com>
Acked-by: Jeff Johnson <quic_jjohnson@quicinc.com>
Signed-off-by: Kalle Valo <quic_kvalo@quicinc.com>
Link: https://msgid.link/20240320171305.655288-2-quic_rgnanase@quicinc.com
