We have a MAC component (which is inside the SoC) and it has several
different HW steps. 3 bits used to be enough but now we need 4-bits
to represent all the different steps.
Properly support 4-bits in the MAC step value by refactoring all the
current handling of the MAC step/dash.
Already from family 8000 and up the dash (bits 0-1) no longer exists
and the step (until 8000 bits 2-3) consists of the dash bits as well.
To do this remove the CSR_HW_REV_STEP and the CSR_HW_REV_DASH
macros, replace them with CSR_HW_REV_STEP_DASH and add hw_rev_step
into the trans struct.
In addition remove the CSR_HW_IF_CONFIG_REG_MSK_MAC_STEP and
CSR_HW_IF_CONFIG_REG_MSK_MAC_DASH macros and create a new macro
combining the 2 (this way we don't need shifting or anything else.)
Signed-off-by: Matti Gottlieb <matti.gottlieb@intel.com>
Signed-off-by: Mike Golant <michael.golant@intel.com>
Signed-off-by: Luca Coelho <luciano.coelho@intel.com>
Link: https://lore.kernel.org/r/iwlwifi.20211207160459.2e81a14d1f80.Ia5287e37fb3439d805336837361f6491f958e465@changeid
Signed-off-by: Luca Coelho <luciano.coelho@intel.com>
iwlmei needs to know about the follwing events:
* Association
* De-association
* Country Code change
* SW Rfkill change
* SAR table changes
iwlmei can take the device away from us, so report the new
rfkill type when this happens.
Advertise the required data from the CSME firmware to the
usersapce: mostly, the AP that the CSME firmware is currently
associated to in case there is an active link protection
session.
Generate the HOST_ASSOC / HOST_DISSASSOC messages.
Don't support WPA1 (non-RSNA) for now.
Don't support shared wep either.
We can then determine the AUTH parameter by checking the AKM.
Feed the cipher from the key installation.
SW Rfkill will be implemented later when cfg80211 will
allow us to read the SW Rfkill state.
Co-Developed-by: Ayala Beker <ayala.beker@intel.com>
Signed-off-by: Ayala Beker <ayala.beker@intel.com>
Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
v7: Ayala added her signed-off
remove pointless function declaration
fix a bug due to merge conflict in the HOST_ASSOC message
v8: leave a print if we have a SAP connection on a device we do
not support (yet)
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>
Link: https://lore.kernel.org/r/20211112062814.7502-4-emmanuel.grumbach@intel.com
Fix warnings produced by:
- lockdep_assert_wiphy() in function reg_process_self_managed_hint(),
- wiphy_dereference() in function iwl_mvm_init_fw_regd().
Both function are expected to be called in critical section.
The warnings were discovered when running v5.15 kernel
with debug options enabled:
1)
Hardware name: Google Delbin/Delbin
RIP: 0010:reg_process_self_managed_hint+0x254/0x347 [cfg80211]
...
Call Trace:
regulatory_set_wiphy_regd_sync+0x3d/0xb0
iwl_mvm_init_mcc+0x49d/0x5a2
iwl_op_mode_mvm_start+0x1b58/0x2507
? iwl_mvm_reprobe_wk+0x94/0x94
_iwl_op_mode_start+0x146/0x1a3
iwl_opmode_register+0xda/0x13d
init_module+0x28/0x1000
2)
drivers/net/wireless/intel/iwlwifi/mvm/mac80211.c:263 suspicious rcu_dereference_protected() usage!
...
Hardware name: Google Delbin/Delbin, BIOS Google_Delbin
Call Trace:
dump_stack_lvl+0xb1/0xe6
iwl_mvm_init_fw_regd+0x2e7/0x379
iwl_mvm_init_mcc+0x2c6/0x5a2
iwl_op_mode_mvm_start+0x1b58/0x2507
? iwl_mvm_reprobe_wk+0x94/0x94
_iwl_op_mode_start+0x146/0x1a3
iwl_opmode_register+0xda/0x13d
init_module+0x28/0x100
Fixes: a05829a722 ("cfg80211: avoid holding the RTNL when calling the driver")
Signed-off-by: Łukasz Bartosik <lb@semihalf.com>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>
Link: https://lore.kernel.org/r/20211110215744.5487-1-lukasz.bartosik@semihalf.com
In firmware dumps, currently all kinds of key material may be
included, e.g. in host commands (if firmware crashes during the
processing of a key-related command) or in the TX FIFO(s) if
we have been using in-TX-command key material.
Additionally, some firmware versions will advertise sections
of their internal data to not dump, due to them containing some
sensitive data.
Add some infrastructure to allow scrubbing this data out, as
dependent on the opmode's idea of what will need to be done.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Signed-off-by: Luca Coelho <luciano.coelho@intel.com>
Link: https://lore.kernel.org/r/iwlwifi.20211017123741.360cc8fe55b1.Ie3bd3ece38043969f7e116e61a6ec1197a58d78b@changeid
Signed-off-by: Luca Coelho <luciano.coelho@intel.com>
Due to a rebase damage, we lost the rtnl_lock() when the patch was
sent out. This causes an RTNL imbalance and failed assertions, due to
missing RTNL protection, for instance:
RTNL: assertion failed at net/wireless/reg.c (4025)
WARNING: CPU: 60 PID: 1720 at net/wireless/reg.c:4025 regulatory_set_wiphy_regd_sync+0x7f/0x90 [cfg80211]
Call Trace:
iwl_mvm_init_mcc+0x170/0x190 [iwlmvm]
iwl_op_mode_mvm_start+0x824/0xa60 [iwlmvm]
iwl_opmode_register+0xd0/0x130 [iwlwifi]
init_module+0x23/0x1000 [iwlmvm]
Fix this by adding the missing rtnl_lock() back to the code.
Fixes: eb09ae93da ("iwlwifi: mvm: load regdomain at INIT stage")
Link: https://lore.kernel.org/lkml/CAHk-=wjB_zBwZ+WR9LOpvgjvaQn=cqryoKigod8QnZs=iYGEhA@mail.gmail.com/
Reported-by: Linus Torvalds <torvalds@linux-foundation.org>
Signed-off-by: Luca Coelho <luciano.coelho@intel.com>
Acked-by: David S. Miller <davem@davemloft.net>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
When TVQM is enabled (iwl_mvm_has_new_tx_api() is true), then
queue numbers are just sequentially assigned 0, 1, 2, ...
Prior to TVQM, in DQA, there were some statically allocated
queue numbers:
* IWL_MVM_DQA_AUX_QUEUE == 1,
* both IWL_MVM_DQA_INJECT_MONITOR_QUEUE and
IWL_MVM_DQA_P2P_DEVICE_QUEUE == 2, and
* IWL_MVM_DQA_AP_PROBE_RESP_QUEUE == 9.
Now, these values are assigned to the members mvm->aux_queue,
mvm->snif_queue, mvm->probe_queue and mvm->p2p_dev_queue by
default. Normally, this doesn't really matter, and if TVQM is
in fact available we override them to the real values after
allocating a queue for use there.
However, this allocation doesn't always happen. For example,
for mvm->p2p_dev_queue (== 2) it only happens when the P2P
Device interface is started, if any. If it's not started, the
value in mvm->p2p_dev_queue remains 2. This wouldn't really
matter all that much if it weren't for iwl_mvm_is_static_queue()
which checks a queue number against one of those four static
numbers.
Now, if no P2P Device or monitor interface is added then queue
2 may be dynamically allocated, yet alias mvm->p2p_dev_queue or
mvm->snif_queue, and thus iwl_mvm_is_static_queue() erroneously
returns true for it. If it then gets full, all interface queues
are stopped, instead of just backpressuring against the one TXQ
that's really the only affected one.
This clearly can lead to issues, as everything is stopped even
if just a single TXQ filled its corresponding HW queue, if it
happens to have an appropriate number (2 or 9, AUX is always
reassigned.) Due to a mac80211 bug, this also led to a situation
in which the queues remained stopped across a deauthentication
and then attempts to connect to a new AP started failing, but
that's fixed separately.
Fix all of this by simply initializing the queue numbers to
the invalid value until they're used, if TVQM is enabled, and
also setting them back to that value when the queues are later
freed again.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Signed-off-by: Luca Coelho <luciano.coelho@intel.com>
Link: https://lore.kernel.org/r/iwlwifi.20210802172232.2e47e623f9e2.I9b0830dafbb68ef35b7b8f0f46160abec02ac7d0@changeid
Signed-off-by: Luca Coelho <luciano.coelho@intel.com>
The firmware can now request SMPS (due to thermal conditions), add
some code to honour such requests and bubble them up through the
stack, subject to our other SMPS constraints, e.g. from Bluetooth.
Then, if the firmware requests SMPS, then we know that it supports
a small extension to the PHY configuration API where a chain mask
of 0 means "use 1 but pick which one yourself", so in this case we
use that extension.
During firmware restart, we stay in the previous state, and the FW
will send us a notification at startup (only) if the temperature is
below the lower or above the high threshold, to sync the state.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Signed-off-by: Luca Coelho <luciano.coelho@intel.com>
Link: https://lore.kernel.org/r/iwlwifi.20210617100544.85656b7684b9.I7a661a0758d070a750d3a91874d1a0f5fab9febc@changeid
Signed-off-by: Luca Coelho <luciano.coelho@intel.com>
No need to pass the dbgfs_dir just to assign it to mvm.
Assign to mvm and then call iwl_mvm_dbgfs_register.
This is a preparation towards the addition of a delayed
op_mode_start flow.
This will allow to split the op_mode_start flow.
Registration to debugfs must happen after we register to
mac80211 and the registration to mac80211 will soon be
delayed in certain cases. In order not to have to remember
the debugfs_dir in a separate variable, just set it into
the mvm structure so that it can be usable later.
Declare mvm->debugfs_dir in the iwl_mvm structure even when
IWLWIFI_DEBUGFS isn't enabled to simplify the source code.
Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
Signed-off-by: Luca Coelho <luciano.coelho@intel.com>
Link: https://lore.kernel.org/r/iwlwifi.20210210171218.a92ee491863d.I047923aa3598fbf4fb6fce2cdff75a4969fedd76@changeid
Signed-off-by: Luca Coelho <luciano.coelho@intel.com>
iwlwifi patches intended for v5.12
* Check FW notification sizes for robustness;
* Improvements in the NAPI implementation;
* Implement a workaround for CCA-EXT;
* Add new FW API support;
* Fix a CSA bug;
* Implement PHY integration version parsing;
* A bit of refactoring;
* One more CSA bug fix, this time in the AP side;
* Support for new So devices and a bit of reorg;
* Per Platform Antenna Gain (PPAG) fixes and improvements;
* Improvements in the debug framework;
* Some other clean-ups and small fixes.
# gpg: Signature made Fri 05 Feb 2021 12:04:21 PM EET using RSA key ID 1A3CC5FA
# gpg: Good signature from "Luciano Roth Coelho (Luca) <luca@coelho.fi>"
# gpg: aka "Luciano Roth Coelho (Intel) <luciano.coelho@intel.com>"
We shouldn't trust the firmware with the sizes (or contents)
of notifications, accessing too much data could cause page
faults if the data doesn't fit into the allocated space. This
applies more on older NICs where multiple notifications can
be in a single RX buffer.
Add a general framework for checking a minimum size of any
notification in the RX handlers and use it for most. Some RX
handlers were already checking and I've moved the checks,
some more complex checks I left and made them _NO_SIZE for
the RX handlers.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Signed-off-by: Luca Coelho <luciano.coelho@intel.com>
Link: https://lore.kernel.org/r/iwlwifi.20210117130510.3e155d5e5f90.I2121fa4ac7cd7eb98970d84b793796646afa3eed@changeid
Signed-off-by: Luca Coelho <luciano.coelho@intel.com>
