In order to simplify the driver even further and to remove the
boilerplate code, rewrite the audio interface to use the DRM HDMI Audio
framework.
Audio InfoFames are controlled centrally via the DRM HDMI framework.
Correct InfoFrame data is programmed at the atomic_pre_enable() time (if
it was set before, drm_atomic_helper_connector_hdmi_update_infoframes()
takes care of writing all InfoFrames, including the Audio one.) or
during msm_hdmi_bridge_audio_prepare() when the new stream is started.
All audio data frame management is deferred to
msm_hdmi_bridge_audio_prepare() and msm_hdmi_bridge_audio_shutdown().
Reviewed-by: Maxime Ripard <mripard@kernel.org>
Reviewed-by: Abhinav Kumar <quic_abhinavk@quicinc.com>
Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
Patchwork: https://patchwork.freedesktop.org/patch/639663/
Link: https://lore.kernel.org/r/20250226-bridge-hdmi-connector-v8-7-340af24b35cc@linaro.org
Updates for v6.14
MDSS:
- properly described UBWC registers
- added SM6150 (aka QCS615) support
MDP4:
- several small fixes
DPU:
- added SM6150 (aka QCS615) support
- enabled wide planes if virtual planes are enabled (by using two SSPPs for a single plane)
- fixed modes filtering for platforms w/o 3DMux
- fixed DSPP DSPP_2 / _3 links on several platforms
- corrected DSPP definitions on SDM670
- added CWB hardware blocks support
- added VBIF to DPU snapshots
- dropped struct dpu_rm_requirements
DP:
- reworked DP audio support
DSI:
- added SM6150 (aka QCS615) support
GPU:
- Print GMU core fw version
- GMU bandwidth voting for a740 and a750
- Expose uche trap base via uapi
- UAPI error reporting
Signed-off-by: Dave Airlie <airlied@redhat.com>
From: Rob Clark <robdclark@gmail.com>
Link: https://patchwork.freedesktop.org/patch/msgid/CAF6AEGsutUu4ff6OpXNXxqf1xaV0rV6oV23VXNRiF0_OEfe72Q@mail.gmail.com
The continual trickle of small conversion patches is grating on me, and
is really not helping. Just get rid of the 'remove_new' member
function, which is just an alias for the plain 'remove', and had a
comment to that effect:
/*
* .remove_new() is a relic from a prototype conversion of .remove().
* New drivers are supposed to implement .remove(). Once all drivers are
* converted to not use .remove_new any more, it will be dropped.
*/
This was just a tree-wide 'sed' script that replaced '.remove_new' with
'.remove', with some care taken to turn a subsequent tab into two tabs
to make things line up.
I did do some minimal manual whitespace adjustment for places that used
spaces to line things up.
Then I just removed the old (sic) .remove_new member function, and this
is the end result. No more unnecessary conversion noise.
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Updates for v6.7
DP:
- use existing helpers for DPCD handling instead of open-coded functions
- set the subconnector type according to the plugged cable / dongle
skip validity check for DP CTS EDID checksum
DPU:
- continued migration of feature flags to use core revision checks
- reworked interrupts code to use '0' as NO_IRQ, removed raw IRQ indices
from log / trace output
gpu:
- a7xx support (a730, a740)
- fixes and additional speedbins for a635, a643
core:
- decouple msm_drv from kms to more cleanly support headless devices (like
imx5+a2xx)
From: Rob Clark <robdclark@gmail.com>
Link: https://patchwork.freedesktop.org/patch/msgid/CAF6AEGvzkBL2_OgyOeP_b6rVEjrNdfm8jcKzaB04HqHyT5jYwA@mail.gmail.com
Signed-off-by: Dave Airlie <airlied@redhat.com>
The .remove() callback for a platform driver returns an int which makes
many driver authors wrongly assume it's possible to do error handling by
returning an error code. However the value returned is (mostly) ignored
and this typically results in resource leaks. To improve here there is a
quest to make the remove callback return void. In the first step of this
quest all drivers are converted to .remove_new() which already returns
void.
Trivially convert the msm drm drivers from always returning zero in the
remove callback to the void returning variant.
Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
Signed-off-by: Javier Martinez Canillas <javierm@redhat.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20230507162616.1368908-32-u.kleine-koenig@pengutronix.de
The DT of_device.h and of_platform.h date back to the separate
of_platform_bus_type before it as merged into the regular platform bus.
As part of that merge prepping Arm DT support 13 years ago, they
"temporarily" include each other. They also include platform_device.h
and of.h. As a result, there's a pretty much random mix of those include
files used throughout the tree. In order to detangle these headers and
replace the implicit includes with struct declarations, users need to
explicitly include the correct includes.
Signed-off-by: Rob Herring <robh@kernel.org>
Acked-by: Sam Ravnborg <sam@ravnborg.org>
Reviewed-by: Steven Price <steven.price@arm.com>
Acked-by: Liviu Dudau <liviu.dudau@arm.com>
Reviewed-by: Kieran Bingham <kieran.bingham+renesas@ideasonboard.com>
Acked-by: Robert Foss <rfoss@kernel.org>
Signed-off-by: Thierry Reding <treding@nvidia.com>
Link: https://patchwork.freedesktop.org/patch/msgid/20230714174545.4056287-1-robh@kernel.org
Pull ARM SoC driver updates from Arnd Bergmann:
"As usual, there are lots of minor driver changes across SoC platforms
from NXP, Amlogic, AMD Zynq, Mediatek, Qualcomm, Apple and Samsung.
These usually add support for additional chip variations in existing
drivers, but also add features or bugfixes.
The SCMI firmware subsystem gains a unified raw userspace interface
through debugfs, which can be used for validation purposes.
Newly added drivers include:
- New power management drivers for StarFive JH7110, Allwinner D1 and
Renesas RZ/V2M
- A driver for Qualcomm battery and power supply status
- A SoC device driver for identifying Nuvoton WPCM450 chips
- A regulator coupler driver for Mediatek MT81xxv"
* tag 'soc-drivers-6.3' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc: (165 commits)
power: supply: Introduce Qualcomm PMIC GLINK power supply
soc: apple: rtkit: Do not copy the reg state structure to the stack
soc: sunxi: SUN20I_PPU should depend on PM
memory: renesas-rpc-if: Remove redundant division of dummy
soc: qcom: socinfo: Add IDs for IPQ5332 and its variant
dt-bindings: arm: qcom,ids: Add IDs for IPQ5332 and its variant
dt-bindings: power: qcom,rpmpd: add RPMH_REGULATOR_LEVEL_LOW_SVS_L1
firmware: qcom_scm: Move qcom_scm.h to include/linux/firmware/qcom/
MAINTAINERS: Update qcom CPR maintainer entry
dt-bindings: firmware: document Qualcomm SM8550 SCM
dt-bindings: firmware: qcom,scm: add qcom,scm-sa8775p compatible
soc: qcom: socinfo: Add Soc IDs for IPQ8064 and variants
dt-bindings: arm: qcom,ids: Add Soc IDs for IPQ8064 and variants
soc: qcom: socinfo: Add support for new field in revision 17
soc: qcom: smd-rpm: Add IPQ9574 compatible
soc: qcom: pmic_glink: remove redundant calculation of svid
soc: qcom: stats: Populate all subsystem debugfs files
dt-bindings: soc: qcom,rpmh-rsc: Update to allow for generic nodes
soc: qcom: pmic_glink: add CONFIG_NET/CONFIG_OF dependencies
soc: qcom: pmic_glink: Introduce altmode support
...
msm-next for v6.3
There is one devfreq patch, maintainer acked to land via msm-next to
avoid a build break on platforms that do not support PM_DEVFREQ. And
otherwise the usual assortment:
GPU:
- Add MSM_SUBMIT_BO_NO_IMPLICIT
- a2xx: Support to load legacy firmware
- a6xx: GPU devcore dump updates for a650/a660
- GPU devfreq tuning and fixes
DPU, DSI, MDSS:
- Support for SM8350, SM8450 SM8550 and SC8280XP platform
Core:
- Added bindings for SM8150 (driver support already present)
DPU:
- Partial support for DSC on SM8150 and SM8250
- Fixed color transformation matrix being lost on suspend/resume
- Include DSC blocks into register snapshot
- Misc HW catalog fixes
DP:
- Support for DP on SDM845 and SC8280XP platforms
- HPD fixes
- Support for limiting DP link rate via DT property, this enables
- Support for HBR3 rates.
DSI:
- Validate display modes according to the DSI OPP table
- DSI PHY support for the SM6375 platform
- Fixed byte intf clock selection for 14nm PHYs
- Fix the case of empty OPP tables (fixing db410c)
- DT schema rework and fixes
HDMI:
- Turn 8960 HDMI PHY into clock provider,
- Make 8960 HDMI PHY use PXO clock from DT
MDP5:
- Schema conversion to YAML
Signed-off-by: Dave Airlie <airlied@redhat.com>
From: Rob Clark <robdclark@gmail.com>
Link: https://patchwork.freedesktop.org/patch/msgid/CAF6AEGv6zQ-zsgS+NG+WuV=tk51q9vA2QdKqYhNgiXQddAdZjA@mail.gmail.com
Due to holidays we started -next with more -fixes in-flight than
usual, and people have been asking where they are. Backmerge to get
things better in sync.
Conflicts:
- Tiny conflict in drm_fbdev_generic.c between variable rename and
missing error handling that got added.
- Conflict in drm_fb_helper.c between the added call to vgaswitcheroo
in drm_fb_helper_single_fb_probe and a refactor patch that extracted
lots of helpers and incidentally removed the dev local variable.
Readd it to make things compile.
Signed-off-by: Daniel Vetter <daniel.vetter@ffwll.ch>
drm-misc-next for v6.3:
UAPI Changes:
* fourcc: Document Open Source user waiver
Cross-subsystem Changes:
* firmware: fix color-format selection for system framebuffers
Core Changes:
* format-helper: Add conversion from XRGB8888 to various sysfb formats;
Make XRGB8888 the only driver-emulated legacy format
* fb-helper: Avoid blank consoles from selecting an incorrect color format
* probe-helper: Enable/disable HPD on connectors plus driver updates
* Use drm_dbg_ helpers in several places
* docs: Document defaults for CRTC backgrounds; Document use of drm_minor
Driver Changes:
* arm/hdlcd: Use new debugfs helpers
* gud: Use new debugfs helpers
* panel: Support Visionox VTDR6130 AMOLED DSI; Support Himax HX8394; Convert
many drivers to common generic DSI write-sequence helper
* v3d: Do not opencode drm_gem_object_lookup()
* vc4: Various HVS an CRTC fixes
* vkms: Fix SEGFAULT from incorrect GEM-buffer mapping
* Convert various drivers to i2c probe_new()
Signed-off-by: Dave Airlie <airlied@redhat.com>
From: Thomas Zimmermann <tzimmermann@suse.de>
Link: https://patchwork.freedesktop.org/patch/msgid/Y8ADeSzZDj+tpibF@linux-uq9g
