For channel contexts, mac80211 currently uses the cfg80211
chandef struct (control channel, center freq(s), width) to
define towards drivers and internally how these behave. In
fact, there are _two_ such structs used, where the min_def
can reduce bandwidth according to the stations connected.
Unfortunately, with EHT this is longer be sufficient, at
least not for all hardware. EHT requires that non-AP STAs
that are connected to an AP with a lower bandwidth than it
(the AP) advertises (e.g. 160 MHz STA connected to 320 MHz
AP) still be able to receive downlink OFDMA and respond to
trigger frames for uplink OFDMA that specify the position
and bandwidth for the non-AP STA relative to the channel
the AP is using. Therefore, they need to be aware of this,
and at least for some hardware (e.g. Intel) this awareness
is in the hardware. As a result, use of the "same" channel
may need to be split over two channel contexts where they
differ by the AP being used.
As a first step, introduce a concept of a channel request
('chanreq') for each interface, to control the context it
requests. This step does nothing but reorganise the code,
so that later the AP's chandef can be added to the request
in order to handle the EHT case described above.
Link: https://msgid.link/20240129194108.2e88e48bd2e9.I4256183debe975c5ed71621611206fdbb69ba330@changeid
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
There's only one user of this code, which is STA unblock
during sleep for uAPSD on really old devices. Instead of
having this all through the API with calls up and down,
just implemented a special-case CMD_BLOCK_TXQS flag for
this, it's only needed in the old gen1 transport.
While at it, fix a complain that lockdep would have, as
we lock the cmd queue and then the TXQs in the reclaim
by using spin_lock_nested(). We no longer need to disable
BHs in iwl_trans_pcie_block_txq_ptrs() since it's called
with them disabled already.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Signed-off-by: Miri Korenblit <miriam.rachel.korenblit@intel.com>
Link: https://msgid.link/20231207044813.2bd95e0570fc.I16486dbc82570d2f73a585872f5394698627310d@changeid
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
The firmware / hardware of devices supporting RSS is able to report
duplicates and packets that time out inside the reoder buffer. We can
now remove all the complex logic that was implemented to keep all the Rx
queues more the less synchronized: we used to send a message to all the
queues through the firmware to teach the different queues about what is
the current SSN every 2048 packets.
Now that we rely on the firmware / hardware to detect duplicates, we can
completely remove the code that did that in the driver and it has been
reported that this code was spuriously dropping legit packets.
Suggested-by: Sultan Alsawaf <sultan@kerneltoast.com>
Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
Signed-off-by: Gregory Greenman <gregory.greenman@intel.com>
Link: https://lore.kernel.org/r/20231017115047.54cf4d3d5956.Ic06a08c9fb1e1ec315a4b49d632b78b8474dab79@changeid
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Roee reported various hard-to-debug crashes with pings in
EHT aggregation scenarios. Enabling KASAN showed that we
access the BAID allocation out of bounds, and looking at
the code a bit shows that since the reorder buffer entry
(struct iwl_mvm_reorder_buf_entry) is 128 bytes if debug
such as lockdep is enabled, then staring from an agg size
512 we overflow the size calculation, and allocate a much
smaller structure than we should, causing slab corruption
once we initialize this.
Fix this by simply using u32 instead of u16.
Reported-by: Roee Goldfiner <roee.h.goldfiner@intel.com>
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Signed-off-by: Gregory Greenman <gregory.greenman@intel.com>
Link: https://lore.kernel.org/r/20230620125813.f428c856030d.I2c2bb808e945adb71bc15f5b2bac2d8957ea90eb@changeid
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
There are a number of upcoming things in both the stack and
drivers that would otherwise conflict, so merge wireless to
wireless-next to be able to avoid those conflicts.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Johannes Berg says:
====================
Major stack changes:
* TC offload support for drivers below mac80211
* reduced neighbor report (RNR) handling for AP mode
* mac80211 mesh fast-xmit and fast-rx support
* support for another mesh A-MSDU format
(seems nobody got the spec right)
Major driver changes:
Kalle moved the drivers that were just plain C files
in drivers/net/wireless/ to legacy/ and virtual/ dirs.
hwsim
* multi-BSSID support
* some FTM support
ath11k
* MU-MIMO parameters support
* ack signal support for management packets
rtl8xxxu
* support for RTL8710BU aka RTL8188GU chips
rtw89
* support for various newer firmware APIs
ath10k
* enabled threaded NAPI on WCN3990
iwlwifi
* lots of work for multi-link/EHT (wifi7)
* hardware timestamping support for some devices/firwmares
* TX beacon protection on newer hardware
* tag 'wireless-next-2023-03-30' of git://git.kernel.org/pub/scm/linux/kernel/git/wireless/wireless-next: (181 commits)
wifi: clean up erroneously introduced file
wifi: iwlwifi: mvm: correctly use link in iwl_mvm_sta_del()
wifi: iwlwifi: separate AP link management queues
wifi: iwlwifi: mvm: free probe_resp_data later
wifi: iwlwifi: bump FW API to 75 for AX devices
wifi: iwlwifi: mvm: move max_agg_bufsize into host TLC lq_sta
wifi: iwlwifi: mvm: send full STA during HW restart
wifi: iwlwifi: mvm: rework active links counting
wifi: iwlwifi: mvm: update mac config when assigning chanctx
wifi: iwlwifi: mvm: use the correct link queue
wifi: iwlwifi: mvm: clean up mac_id vs. link_id in MLD sta
wifi: iwlwifi: mvm: fix station link data leak
wifi: iwlwifi: mvm: initialize max_rc_amsdu_len per-link
wifi: iwlwifi: mvm: use appropriate link for rate selection
wifi: iwlwifi: mvm: use the new lockdep-checking macros
wifi: iwlwifi: mvm: remove chanctx WARN_ON
wifi: iwlwifi: mvm: avoid sending MAC context for idle
wifi: iwlwifi: mvm: remove only link-specific AP keys
wifi: iwlwifi: mvm: skip inactive links
wifi: iwlwifi: mvm: adjust iwl_mvm_scan_respect_p2p_go_iter() for MLO
...
====================
Link: https://lore.kernel.org/r/20230330205612.921134-1-johannes@sipsolutions.net
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
In MLO, some fields of iwl_mvm_vif should be defined in the
context of a link. Define a separate structure for these fields and
add a deflink object to hold it as part of iwl_mvm_vif. Non-MLO legacy
code will use only deflink object while MLO related code will use the
corresponding link from the link array.
It follows the strategy applied in mac80211 for introducing MLO
changes.
The below spatch takes care of updating all driver code to access
fields separated into MLD specific data structure via deflink (need
to convert all references to the fields listed in var to deflink.var
and also to take care of calls like iwl_mvm_vif_from_mac80211(vif)->field).
@iwl_mld_vif@
struct iwl_mvm_vif *v;
struct ieee80211_vif *vv;
identifier fn;
identifier var = {bssid, ap_sta_id, bcast_sta, mcast_sta,
beacon_stats, smps_requests, probe_resp_data,
he_ru_2mhz_block, cab_queue, phy_ctxt,
queue_params};
@@
(
v->
- var
+ deflink.var
|
fn(vv)->
- var
+ deflink.var
)
Signed-off-by: Gregory Greenman <gregory.greenman@intel.com>
Link: https://lore.kernel.org/r/20230328104948.4896576f0a9f.Ifaf0187c96b9fe52b24bd629331165831a877691@changeid
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
For TM/FTM frames, report the hardware timestamps reported by the
fw as part of the RX/TX status. Since the fw reports the timestamps
in a dedicated notification (and not as part of the RX/TX status),
hold the frame until the fw timestamps notification is received.
Timestamping is enabled when a station is connected and disabled
when disconnected. For AP interface, only the first station will
have timestamping enabled since the fw only supports timestamping
for one peer.
Signed-off-by: Avraham Stern <avraham.stern@intel.com>
Signed-off-by: Gregory Greenman <gregory.greenman@intel.com>
Link: https://lore.kernel.org/r/20230320122330.e0392d498101.I9bf12c8ecfb3f17253a13dc48a48647ddd6e7855@changeid
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Some recent upstream debugging uncovered the fact that in
iwlwifi, the TXQ list manipulation is racy.
Introduce a new state bit for when the TXQ is completely
ready and can be used without locking, and if that's not
set yet acquire the lock to check everything correctly.
Reviewed-by: Benjamin Berg <benjamin.berg@intel.com>
Tested-by: Jose Ignacio Tornos Martinez <jtornosm@redhat.com>
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
This could race if the queue is redirected while full, then
the flushing internally would start it while it's not yet
usable again. Fix it by using two state bits instead of just
one.
Reviewed-by: Benjamin Berg <benjamin.berg@intel.com>
Tested-by: Jose Ignacio Tornos Martinez <jtornosm@redhat.com>
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
